CUTEK® Extreme Samples

CUTEK Sample Notes

A few things to note when applying your CUTEK® Pre-Mixed Samples:
The samples are provided at a double strength of CUTEK® Colourtone - one coat
with the sample will represent the color intensity of two coats at single strength, or
one of double strength.
The test area or piece of wood should be bare, clean and dry, before applying,
having the wood in the same (or close) condition as the project will be for the full
application will provide the best conditions for the color selection. Sanding smooth
wood with 80 grit sandpaper will help provide a good color result, ensure it is wiped
free of dust before application. Sanding is not necessary on rough or textured
surfaces.
Knead or massage the package well in order to blend the CUTEK® Colourtone with
the CUTEK® Extreme oil, as settling of the pigment will occur.
Starting with a small amount and spread the sample as thin and evenly as possible,
brushing it over the sample area or piece of wood so as not to over apply. Each Pre-
Mixed Sample will cover approximately 2 square feet, on new smooth wood - apply
as close to that spread rate as possible.
The initial application of the CUTEK® Extreme oil will enhance the natural colors and
grain of the wood (it will have a ‘wet look’) which will shine through the CUTEK®
Colourtone, as they are transparent, and it will have an oily sheen. As the oil
penetrates into the wood the wet look will fade down, and you will be left with a matte
finish.
Choosing a sunny area to test or place the sample in will help with the
penetration/drying process. Typically, the surface will be dry in 3-5 days, but
allowing the sample to sit in the sun for 7-10 days will help with the final color
appearance.